This brief focus on drilling of polymer matrix composites for aerospace and defence applications. It gives an introduction to machining of polymer composites and discusses drilling as a processing of composites.

Presents practical solution for composites damage Reports an important issue in aerospace research Focus on a single, specific controlling process

Autorentext
João P. Davim received his PhD degree in Mechanical Engineering from the University of Porto in 1997 and the Aggregation from the University of Coimbra in 2005. Between 1986/96, he was lecturer in University of Porto. Currently, he is an Aggregate Professor at the Department of Mechanical Engineering of the University of Aveiro and the Head of MACTRIB - Machining and Tribology Research Group . He has more 24 years of teaching and research experience in manufacturing, materials and mechanical engineering with special emphasis in Machining & Tribology. He is the Editor in Chief of six international journals, Guest Editor of journals, books Editor, book Series Editor and Scientific Advisory for many international journals and conferences. Presently, he is an Editorial Board member of 15 international journals and acts as reviewer for than 50 prestigious ISI web Science journals. In addition, he has also published as author and co-author more than 30 book chapters and 300 articles in journals and conferences.

Klappentext
Polymeric composites are recognised as good candidates for structural components due to their inherent properties. However, they present several kinds of damages while creating holes for assembly. Delamination is considered the most serious damage since it reduces service life of the component. Thrust and delamination can be controlled by proper drill point geometry. Drilling at high speed is also a current requirement of the aerospace industry.

This book focus on drilling of polymer matrix composites for aerospace and defence applications. The book presents introduction to machining of polymer composites and discusses drilling as a processing of composites.

Inhalt

Introduction.- Drilling of Composites.- Effects of drill points while drilling of composites.- Effects of drill points while drilling at high spindle speed.- Numerical prediction of the critical thrust force causing delamination at hole exit.- Effects of drilling parameters on mechanical strength.- Behavior of composite plates with drilled and molded hole under tensile load.