This book elucidates heat transfer behavior for boiling of dilute emulsions- mixtures of two immiscible fluids- which has received little attention to date. Of the work completed in this area, the majority has been focused on pool boiling where no mean flow is present, and this book is the first major work to be published regarding flow boiling of emulsions. The book includes a comprehensive review and assessment of research on emulsion-based heat transfer. Recent experiments are reported and analyzed to characterize heat transfer in microgap flow boiling via a systematic investigation into the effects of gap size, mass flux, and volume fraction on the heat transfer coefficient and pressure drop. The emulsion used in all experiments comprises droplets of an immiscible electronics cooling fluid suspended in water. The volume provides a complete baseline for flow boiling of water in the microgaps, enabling a determination of the enhancement of the heat transfer coefficient when the disperse component is present. Moreover, a subset of the data set pertains to flow boiling of dilute emulsions over microporous surfaces. The flow conditions for which the microporous surfaces enhance or degrade heat transfer are presented. Finally, this book provides a discussion of the physical phenomena which affect boiling and a set of nondimensional numbers that can be used for correlation.

• Presents a comprehensive investigation of flow boiling of water in a microgap channel which serves as a basis for assessment of the effect of a dilute emulsion on boiling heat transfer.
• Presents a comprehensive investigation of flow boiling of an FC72-in-water dilute emulsion in a microgap channel.
• Presents new measurements of the effects of emulsion volume fraction, gap height and mass flux on heat transfer and pressure drop.
• Presents a systematic investigation of microporous coatings on flow boiling in a microgap.
• Quantifies the range of wall temperature for which heat transfer enhancement is achieved for the dilute emulsion.
• A new dimensionless group accounts for the ratio of sensible heat transfer to the continuous component advected from the wall to conduction through a film of droplets.
• Correlation of the heat transfer coefficient for the entire data set is obtained with 95.7 percent of the measurements falling within ±10% of the predicted values.

Autorentext

Dr. Brandon M. Shadakofsky received his BS in Mechanical Engineering from the University of Wyoming. He then conducted his doctoral research under the guidance of Dr. Francis A Kulacki and received his PhD from the Department of Mechanical Engineering at the University of Minnesota.

Dr. Francis A. Kulacki is a retired Professor in the Department of Mechanical Engineering at the University of Minnesota and distinguished awardee from- among other institutions- the American Society of Mechanical Engineering. His research interests included phase change phenomena and thermal management of electronic devices.